Dell PowerVault 210S Dell PowerVault 20xS Storage Systems Enclosure Services - Page 7
Dell PowerVault 20xS Storage Systems Enclosure Services Expander Module Installation, enclosure - cable
View all Dell PowerVault 210S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
This section provides the procedure for installing the enclosure services expander module on the Dell PowerVault 20xS storage system. To install the enclosure services expander module, perform the following steps. NOTE: To perform the following installation and subsequent tasks, you view the PowerVault 20xS storage system from its back panel. 1. Turn off the storage system. 2. Disconnect the power cable(s) from the electrical outlet and the power supply. 3. Using a Phillips-head screwdriver, loosen the captive screw at the top of the existing module on the left-back side of the storage system (see Figure 1-2). 4. Grasp the handle of the existing module and pull it from the module bay. captive screw enclosure services (expander) module handle Dell PowerVault 20xS Storage Systems Enclosure Services Expander Module Installation 1-5