Dell Precision M4400 Service Manual - Page 44
Palm Rest Assembly - heat
View all Dell Precision M4400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Back to Contents Page Palm Rest Assembly Dell Precision™ Service Manual Removing the Palm Rest Assembly Replacing the Palm Rest Assembly Removing the Palm Rest Assembly CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance. 1. Follow the instructions in Before Working on Your Computer. 2. Remove the bottom of the base assembly (see Removing the Bottom of the Base Assembly). 3. Remove the hard drive (see Removing the Hard Drive). 4. Remove the modular drive (see Removing the Modular Drive). 5. Remove the fan and the two heat sinks (see Heat Sinks). 6. Remove the hinge covers (see Removing the Hinge Covers). 7. Remove the display assembly (see Display Assembly). 8. Remove the keyboard (see Removing the Keyboard). 9. Turn the computer over and remove ten M2.5 x 5-mm screws and one M2.5 x 8-mm screw. 10. Loosen the three captive screws on the underside of the laptop with the front edge toward you: l One screw near the front of the right-side edge of the laptop l One in the middle of the left side edge of the laptop l One near the upper left corner, marked with an "S". 1 M2.5 x 5-mm screw (10) 2 captive screw (near hard drive) 3 M2.5 x 8-mm screw (1) 4 captive screw (near optical bay) 5 captive screw (near I/O card) 11. Turn the computer topside up and remove the four M2.5 x 5-mm screws that secure the thermal plate, then remove the thermal plate.