Denon AVR4810CI Owners Manual - English - Page 41

Getting Started Connections Settings Playback Multi-zone Remote Control Information Troubleshooting Specifications Make the Optimal Speaker Settings, and Correct the Room Acoustics (Audyssey™ Auto Setup) Subwoofer Level Error Message and How to Adjust The optimal level of the subwoofer channel is 75 dB. During subwoofer level measurement (d:Perform Audyssey Auto Setup, " STEP2 : Speaker Detection" (vpage 35), 1 - q), an error message is displayed when the subwoofer level is outside the 72 ~ 78 dB range. When using a subwoofer with built-in amplifier (active type), adjust the subwoofer volume so that the subwoofer level is within the 72 ~ 78 dB range. Check the Measuring Results and Equalizer Type after Audyssey Auto Setup (Parameter Check) 1 Select "SW Level Matching" and then press ENTER. 3 Adjust the volume control on your subwoofer so that the measured level is within the 72 ~ 78 dB range. Blue This is displayed after Audyssey Auto Setup is completed. 1 Press i to select "Parameter Check", and then press ENTER or p. 2 Select "SW Test Start" and then press ENTER. Subwoofer level measurement begins. During measuring, a "Testing ..." message is displayed. The measured level appears on the level indicator after about 3 ~ 5 seconds. Red b If the measured level is within the 72 ~ 78 dB range, the level indicator is blue. 4 When the measured level is within the 72 ~ 78 dB range, press ENTER. 5 Select "Next" and then press ENTER. Proceed to "d:Perform Audyssey Auto Setup, STEP2 : Speaker Detection" (vpage 35), 1 - w. 2 Press ui to select the item you want to check, and then press ENTER or p. Speaker Config. Check Distance Check Channel Level Check Crossover Freq. Check EQ Check 3 Press ui to select the channel you want to check. The measurement result of each speaker is displayed. b When you selected "EQ Check" in step 2, press ui to select the Correction curve you want to check ("Audyssey" or "Audyssey Flat"). b When you want to check another item, press RETURN. Pressing RETURN returns you to step 2; from there, proceed to steps 2 and 3. b If the measured level is outside the 72 ~ 78 dB range, the level indicator is red. b When measuring stops, press ENTER. If you set "Restore" to "Yes", you can return to Audyssey Auto Setup measurement result (value calculated at the start by MultEQ XT) even when you have changed each setting manually. 38 Main remote control unit operation buttons :Displaying the menu Cancel the menu :Moves the cursor (Up/Down/Left/Right) :Confirm the setting :Return to previous menu