Denon DHT-684DVD Owners Manual - Page 34
After starting playback
View all Denon DHT-684DVD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
ENGLISH 3 Select the play mode. Press the SURROUND MODE button, then turn the SELECT knob. Example: Stereo (Main unit) (Remote control unit) To select the surround mode while adjusting the surround parameters, tone defeat or tone control, press the surround mode button then operate the selector. (Main unit) 4 Start playback on the selected component. • For operating instructions, refer to the component's manual. 5 Adjust the volume. The volume level is displayed on the master volume level display. (Main unit) (Remote control unit) The volume can be adjusted within the range of -70 to 0 to 18 dB, in steps of 1 dB. However, when the channel level is set as described on page 37, if the volume for any channel is set at +1 dB or greater, the volume cannot be adjusted up to 18 dB. (In this case the maximum volume is adjusted to "18 dB - (Maximum value of channel level)".) Input mode when playing DTS sources • Noise will be output if DTS-compatible CDs or LDs are played in the "ANALOG" or "PCM" mode. When playing DTS-compatible sources, be sure to connect the source component to the digital input jacks (OPTICAL/COAXIAL) and set the input mode to "DTS". Input mode display • In the AUTO mode AUTO INPUT PCM DTS • In the DIGITAL PCM mode AUTO INPUT PCM DTS • In the DIGITAL DTS mode AUTO INPUT PCM DTS • In the ANALOG mode AUTO INPUT PCM DTS Input signal display • DOLBY DIGITAL SIGNAL DIGITAL • DTS SIGNAL DIGITAL • PCM SIGNAL DIGITAL One of these lights, depending on the input signal. DIGITAL ANALOG DIGITAL DIGITAL ANALOG The DIGITAL indicator lights when digital signals are being input properly. If the DIGITAL indicator does not light, check whether the digital input component setup (page 25) and connections are correct and whether the component's power is turned on. NOTE: • The DIGITAL indicator will light when playing CD-ROMs containing data other than audio signals, but no sound will be heard. After starting playback [1] Adjusting the sound quality (tone) 1 The tone switches as follows each time the TONE CONTROL button is pressed. BASS TREBLE (Main unit) 2 With the name of the volume to be adjusted selected, turn the SELECT knob to adjust the level. (Main unit) • To increase the bass or treble: Turn the control clockwise. (The bass or treble sound can be increased to up to +12 dB in steps of 2 dB.) • To decrease the bass or treble: Turn the control counterclockwise. (The bass or treble sound can be decreased to up to -12 dB in steps of 2 dB.) 231 3 If you do not want the bass and treble to be adjusted, turn on the tone defeat mode. The signals do not pass through the bass and treble adjustment circuits, so it provides higher quality sound. (Main unit) 34