Dewalt DWE43214NVS Instruction Manual - Page 10
Flanges and Wheels
View all Dewalt DWE43214NVS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
English (spindle facing user) but self-locks in the counterclockwise direction. • Two-touchTM: In this position the engaging face is straight and squared off. It will NOT ride over to the next alignment hole unless guard release lever is pressed and held while simultaneously rotating the guard in either a clockwise or counter-clockwise direction (spindle facing user). One-TouchTM Fig. C Two-TouchTM 18 7 2. Align the lugs 15 on the guard with the slots 16 on the gear case cover. 3. Push the guard down until the guard lugs engage and rotate them in the groove on the gear case cover. Release the guard release lever. 4. To position the guard: One-touchTM: Rotate the guard clockwise into the desired working position. Press and hold the guard release lever 7 to rotate the guard in the counter- clockwise direction. Two-touchTM: Press and hold the guard release lever 7 . Rotate the guard clockwise or counter- clockwise into the desired working position. NOTE: The guard body should be positioned between the spindle and the operator to provide maximum operator protection. The guard release lever should snap into one of the alignment holes 14 on the guard collar. This ensures that the guard is secure. 5. To remove the guard, follow steps 1-3 of these instructions in reverse. Fig. D 14 15 26 16 7 Setting Guard Adjustment Options To adjust the guard release lever 7 for desired adjustment option: 1. Remove screw 18 using a T20 bit. 2. Remove the guard release lever taking note of the spring position. Choose the end of the lever for the desired adjustment option. One-touch will use the slanted end of the lever 7 to engage the alignment holes 14 on the guard collar. Two-touch will use the squared end to engage the alignment holes 14 on the guard collar. 3. Replace the lever, positioning the chosen end under the spring 26 . Ensure the lever is in proper contact with the spring. 4. Replace screw and torque to 2.0-3.0N-m. Ensure proper installation with spring return function by depressing guard release lever 7 . Mounting Guard (Fig. D) CAUTION: Prior to mounting guard, ensure the screw, lever, and spring are fitted correctly before mounting the guard. 1. With the spindle facing the operator, press and hold the guard release lever 7 . 8 Flanges and Wheels CAUTION: Turn unit off and unplug the tool before making any adjustments or removing or installing attachments or accessories. Mounting Non-Hubbed Wheels (Fig. E) WARNING: Failure to properly seat the flanges and/or wheel could result in serious injury (or damage to the tool or wheel). CAUTION: Included flanges must be used with depressed center Type 27/42 grinding wheels and Type 1/41 cutting wheels. Refer to the Accessories Chart for more information. WARNING: A closed, two-sided cutting wheel guard is required when using abrasive cutting wheels or diamond coated cutting wheels. WARNING: Use of a damaged flange or guard or fail ure to use proper flange and guard can res ult in injury due to wheel breakage and wheel contact. Refer to the Accessories Chart for more information. 1. Place the tool on a table, guard up.