Edimax EW-7438APn Manual - Page 54
IV-1., Configuring your IP address, Static IP users, 168.2.2, 168.2.x x
View all Edimax EW-7438APn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
IV. Appendix IV-1. Configuring your IP address For first-time access, the URL http://EdimaxAP** will not work for static IP users. For first time access to the URL http://EdimaxAP** your computer must be set to use a dynamic IP address. This means your computer can obtain an IP address automatically from a DHCP server. You can check if your computer is set to use a dynamic IP address by following IV-1-1. How to check that your computer uses a dynamic IP address. Static IP users can use the access point's default IP address 192.168.2.2 instead. But in order to do so, you need to temporarily modify your computer's IP address to be in the same IP address subnet e.g. 192.168.2.x (x = 3 - 254). The procedure for modifying your IP address varies across different operating systems; please follow the guide appropriate for your operating system in IV-1-2. How to modify the IP address of your computer. Static IP users please make a note of your static IP before you change it. You can assign a new IP address to the access point which is within the subnet of your network using the browser based configuration interface (refer to III-6. System Utility). Then static IP users can also use the URL http://EdimaxAP** for future access to iQ Setup or the browser based configuration interface. Please remember to change your IP address back to its original value after the access point is properly configured. 54