Electrolux E36DF76TPS Installation Instructions English - Page 14

30" & 36" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS 8 Install Anti-Tip Bracket To reduce the risk of tipping the appliance, the appliance must be secured to the floor by the properly installed anti-tip bracket and screws packed with the range. These parts are located in the oven. Failure to install the anti-tip bracket will allow the range to tip over if excessive weight is placed on an open door or if a child climbs on it. Serious injury might result from spilled hot liquids or from the range itself. If range is ever moved to a different location, the antitip brackets must also be moved and installed with the range. Tools Required: • Adjustable Wrench • Ratchet • Drill & 1/8" (0.32 cm) bit • 5/16" (0.8 cm) Nut driver • Level Tip Over Hazard • A child or adult can tip the range and be killed. • Verify the anti-tip device has been installed to floor or wall. • Ensure the anti-tip device is re-engaged to floor or wall when the range is moved. • Do not operate the range without the anti-tip device in place and engaged. • Failure to follow these instructions can result in death or serious burns to children and adults. Range leveling leg Anti-tip bracket 8.1 Locate the Bracket Using the Template Bracket may be located on either the left or right side of the range. Mark the floor or wall where left or right side of the range will be located. Figure 22: Bracket template If rear of range is against the wall or no further than 1/2" (1.3 cm) from wall when installed, you may use the wall or floor mount method. If moulding is installed and does not allow the bracket to fit flush against the wall, remove moulding or mount bracket to the floor. For wall mount, locate the bracket by placing the back edge of the template against the rear wall and the side edge of template on the mark made referencing the side of the range. Place bracket on top of template and mark location of the screw holes in wall. If rear of range is further than 1/2" (1.3 cm) from the wall when installed, attach bracket to the floor. For floor mount, locate the bracket by placing back edge of the template where the rear of the range will be located. Mark the location of the screw holes shown in template. To check if the anti-tip bracket is installed properly, use both arms to grasp the rear edge of the range back. Carefully attempt to tilt range forward. When properly installed, the range should not tilt forward. Refer to the anti-tip bracket installation instructions supplied with your range for proper installation. 14