Electrolux EFLW427UIW Complete Owners Guide English - Page 19
options, select
View all Electrolux EFLW427UIW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Controls and Settings 19 Spin Speed Max (on select models), high, medium and low (on some models) spin speeds are available for each cycle. The spin speed and/or duration of final spin vary from model to model and cycle to cycle. Increasing the spin speed will extract more water, decrease drying time and conserve energy. Decreasing the spin speed will reduce wrinkling. Select low spin speed (on some models) to gently spin items that should be line dried. Use no spin to omit the final spin at the end of the cycle. The load will be very wet. Remove items from the wash drum to drip dry or select a spin only cycle to remove excess water at a more convenient time. Cycle Options The default options for each cycle will automatically be chosen when a cycle is selected. To protect fabrics, not all options are available for all cycles. If an option is not available for a cycle, the indicator will not light. Selecting Options Press the option button to scroll though the options until the indicator light for the desired option flashes, then press select. The indicator light will illuminate when the option has been selected. Follow the same steps to deselect an option. The indicator light will turn off when the option is deselected. options select de-select NOTE If changes to the settings or options are attempted after the cycle starts, you will hear several beeps when the buttons are pressed. To change the settings or options, press start/pause, make the new selections and press start/pause again. All settings or options selected for the cycle, except sanitize (on select models), perfect steamTM (on select models), and stain treatment options, will be remembered and recalled each time that cycle is selected in the future. To return to factory settings, press and hold soil and options buttons at the same time and hold for 3 seconds until the confirmation signal sounds. To prevent unintentional and accidental exposure of delicate material to excess heat or unexpected steam, the sanitize, perfect steamTM and all stain treatment options will need to be reselected each time. Stain Treatment options (on select models) Your washer is equipped with powerful stain treatment tools. Depending on your model, use one of the options below to deal with tough stains on your garments. See step 5 in the Operating Your Washer section in this guide for details on adding stain additives to the dispenser. StainTreat (400 Series Washer) Select this option to add a short initial wash period to available cycles using the stain treatment additives in the stain soak/treat compartment. After the stain wash phase, the load will automatically advance to the main wash cycle. StainTreatII (500 Series Washer) Select this option when available and rotate the cycle selector to rotate through the stain types below. Stain treatment and main detergent will recirculate in the agitating load for approximately 20 minutes and then the washer will advance to the main wash cycle. • Any Stain Recirculating wash solution will be heated by boost heater. • Blood Recirculating wash solution will NOT be heated by boost heater to prevent setting blood stains. • Chocolate Stain wash time is extended with additional heating by boost heater. StainSoak (600 Series Washer) Similar to StainTreatII above with the added feature of detergent/treatment mixing with SmartBoost pump technology before the Stain washing phase. perfect steamTM (on select models) Select this option to add approximately 20 minutes of tumbling in steam. NOTE • Steam may not necessarily be visible inside drum during a steam wash cycle. • Steam may not be present during entire steam wash cycle.