Electrolux EFLW427UIW Complete Owners Guide English - Page 20

20 Controls and Settings IMPORTANT • If steam is selected, rinse temperatures will be elevated. • If the wash cycle is paused or cancelled during a steam cycle, the door will remain locked until it cools. You may manually perform a rinse & spin cycle to cool the internal temperature sooner. • During a steam cycle, steam exiting from the rear vent of the washer is normal and not cause for alarm. Wash Cycle Options extra rinse Use this option when additional rinsing is desired to remove excess dirt and detergent. It is recommended for heavily soiled loads or if household members have sensitive skin. wrinkle release (on select models) After the final spin, the washer will perform a "dry" agitation to loosen the garments from the side of the drum. extended refresh (on select models) Select extended refresh if you will be unable to remove the load right after the cycle is complete. The washer recognizes the load has sat too long and will do a rinse and spin to keep the load fresh for up to 12 hours. When you are ready to remove the load during the extended refresh segment, you must press cancel to end the cycle and open the door. PODS® (on select models) Select this option when using a detergent pack in a model equipped with a PODS® button (on select dispenser only). This option will divert the flow of water to the detergent pack compartment optimizing the detergent pack performance. Control Options control lock To lock the controls between cycles, scroll to the control lock option and press select. The control lock icon will show on the LED display. To unlock the controls scroll to the control lock option again and press select. Use this feature to reduce the likelihood of accidental operation by children. Washer cycles will not run when Control Lock is activated. delay time Use delay time to delay the start of the washing cycle from 30 minutes to 12 hours. After selecting the delay time option, press select button to scroll to the desired delay time. The delay time icon will illuminate on the LED display to indicate the delay time option is activated, The time will begin counting down on the LED display once the washer start/pause button has been pressed. Chime A signal will sound at the end of each cycle (and periodically during extended refresh) if option is activated. To mute or unmute the chime, press and hold the select button for 3 sec. This will not affect any of the other button tones. options select de-select hold 'select' 3 s to mute/unmute Other Features LED display Icons may vary according to model. The estimated total cycle time will be displayed when the cycle is selected. The time may increase if water pressure is low, oversudsing occurs or the load becomes unbalanced. The approximate time remaining will be displayed during the cycle. As the washer progresses through the cycle phases, the row of cycle phase indicators lights up under the cycle time. The eco, control lock, close door, mute (some models) and delay time will also appear on this LED display. PODS® is a registered trademark of Procter & Gamble Company, Cincinnati OH, used under license by Electrolux.