Electrolux EW30EC55G Use and Care Guide - Page 14

Setting Surface Controls OPERAT(NGTHE DUAL SURFACERAD(ANT ELEMENT Both the 30" and 36" cooktops are equipped with dual radiant surface element located as shown in Figs. 1 & 2. A touch key pad on the element controls is used to select one of the 2 positions of the element. Indicator lights on the control panel are used to indicate which coil of the dual radiant element will heat. One indicator light on indicates that only the INNER coil will heat (Fig. 3). Two indicator lights on indicate that both INNER and OUTER coils will heat (Fig. 4). You may switch from either coil setting at any time during cooking. To Operate the Dual Surface Element: Fig. I 1. Place correctly sized cookware on the radiant surface element. 2. Touch and hold the 0 key pad until a beep sound. The power POWER indicator light above the 0 will turn ON. Note: If no other key pad is POWER touched within 20 seconds the request to Power ON the cooktop will clear. Fig. 2 3. Touch and hold the [] pad for the dual element position until a beep ONOFF is heard. The indicator light located above the [] pad will glow. oN OFF Note: If no further pads are touched within 10 seconds the request to power the element ON will clear. . Select the INNER (Fig. 3) or INNER and OUTER (Fig. 4) to heat by touching the (_ key size pad. . Touch hi + pad once to turn ON the power level to HI. Touch rned pad once for Fig. 3 MEDIUM, touch = Io pad once for power level to LO or touch ! pad once to set the warm power level to KEEP WARM setting. . Each touch of the hi + or = |o pad will increase or decrease the power level. Lo is the lowest power level available. Note: The power level may be adjusted at any time while the element is ON. . Start most cooking operations on a higher setting and then turn to a lower setting to finish cooking. Each surface element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area. . When cooking has been completed touch the [] pad once to turn the element OFF oN o_F Fig. 4 and if no other surface element is used touch the (D key pad to turn off the POWER cooktop.Note: The Hot Surface indicator Light will turn ON if the cooktop is still hot and will remain ON until the heating surface area has cooled sufficiently.