Electrolux EW30EC55G Use and Care Guide - Page 16

Setting Surface Controls Fig. I Fig. 2 N/ Fig. 3 KEEP WARMFEATURE m The Warm feature may be used with any of the Cooking Elements. To Turn the Keep Warm Feature ON: 1. To select the Keep Warm feature for any Cooking Element touch the [] key pad for oNOFF the corresponding Cooking Element. , Touch the ! key pad located in the main control area. If no other key pads are pressed wam_ the control will activate the desired Cooking Element at the Keep Warm setting. SABBATHFEATUREMODE When the Sabbath feature is ON, some power level indicator lights in all element controls (Fig. 1), element size and ON/OFF indicators lights will glow and "Sb" (Fig. 2) will appear in the Timer display. The surface elements can be used even if the Sabbath Feature is on. To activate the Sabbath Feature: To set the Sabbath Feature, at least one element should be active. Touch and hold for few seconds the Timer + pad and the _] pad at the same time. After few seconds, lock "Sb" will appear in Timer displays and some power level indicator lights will glow. To turn ON an additional Surface Element when the Sabbath Feature is active: If you turn on a surface element when the oven Sabbath feature is on, the electronic surface element control will record that request and execute it with a 15-30 seconds delay. So the element will start heating 15-30 seconds after the surface element control was turned on. The surface element display will not show the setting. When necessary, it is possible to adjust the power of the surface element but you have to remember that the surface element control will adjust the temperature with the same delay. Note: No element size can be changed when the Sabbath Feature is ON. If needed it has to be selected prior to turn ON the Sabbath Feature. To turn OFF the Surface Element when the Oven Sabbath Mode is active: To shut off the surface element while the Sabbath feature is ON, proceed as usual but take note that the element will immediately turn off without any delay. Note: Only the element [] pad can be used to turn OFF the element. The (D key pad will ONO_F POWER be disabled and can't be used when the Sabbath Feature is ON. To deactivate the Sabbath Feature: Touch and hold for few seconds the Timer .+. pad and the _ pad at the same time. After lock few seconds, "Sb" will disappear from timer display and the indicator lights will turn OFF. The cookotp is now in its normal operation mode. If a power failure occurs when the Sabbath Feature is ON: "SF" (Fig. 3) will appear in the timer display. Any element can be activated by touching the element o.._opad. Note: The size of the element will be the same as the size selected prior the power failure (or Single by default).