Epson ActionScanner II PC User Setup Information - PC - Page 8
Avoid touching the components or the gold contacts on, the interface, they can be damaged by static
View all Epson ActionScanner II PC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
1. Carefully remove the interface card from its packaging, holding it only by its top edges. Then place it on a flat, clean surface. m Caution: Avoid touching the components or the gold contacts on the interface card; they can be damaged by static electricity. 2. Locate jumpers Jl and J2 on the interface card, as shown below. Qo on "=-o "0on -0o0o ;0;n 'nn 3. The settings are printed on the circuit board next to the jumpers. To change a setting, lift off the jumper cap and reinstall it over the appropriate pair of pins. m Caution: Be careful not to bend the jumper pins. 5
1.
2.
3.
Carefully remove the interface card from its packaging,
holding it only by its top edges. Then place it on a flat,
clean surface.
m
Caution:
Avoid touching the components or the gold contacts on
the interface
card;
they can be damaged by static
electricity.
Locate jumpers Jl and J2 on the interface card, as shown
below.
on
on
on
n
Q”-oo;;’
o=“-
0000
n
The settings are printed on the circuit board next to the
jumpers. To change a setting, lift off the jumper cap and
reinstall it over the appropriate pair of pins.
m
Caution:
Be careful not to bend the jumper pins.
5