Epson Expression 10000XL - Photo Edition Start Here Card - Page 4

4 Connect the Scanner Note: If you are installing the optional Network Image Express card, see the instructions in the User's Guide. 1 Connect the scanner to your computer. If you're using USB . . . Plug the square end of the USB cable into the scanner's USB port. Then plug the flat end into any available USB port on your computer or USB hub.  If you're using IEEE 1394 (FireWire®) . . . Plug one end of the IEEE 1394 cable (not included) into the scanner's IEEE 1394 port. Then plug the other end into the IEEE 1394 port on your computer. 2 Slide the transportation lock (the tab over the AC connector) up to the Unlock position. 3 Plug the scanner's power cord into the AC connector. Then plug the other end into a grounded electrical outlet. 4 Press the power button on the front of the scanner to turn it on. The green Ready light blinks for about 30 seconds during initialization, and then stays on when the scanner is ready to use. Power button Caution: If you turn off the scanner, wait at least 10 seconds before turning it back on. Turn over