Epson WorkForce Pro WF-C879R Users Guide - Page 397

If any torn pieces of paper remain inside the product, select Settings > Maintenance > Remove Paper after clearing the paper jam error. Parent topic: Solving Paper Problems Paper Ejection Problems If you have problems with paper ejecting properly, try these solutions: • If paper does not eject fully, you may have set the wrong paper size. Cancel printing to eject the paper. Select the correct paper size when you reprint. • If paper is wrinkled when it ejects, it may be damp or too thin. Load new paper and be sure to select the correct paper type setting when you reprint. Parent topic: Solving Paper Problems Solving Problems Printing from a Computer Check these sections if you have problems while printing from your computer. Nothing Prints Product Icon Does Not Appear in Windows Taskbar Printing is Slow Parent topic: Solving Problems Nothing Prints If you have sent a print job and nothing prints, try these solutions: • Make sure your product is turned on and connected to your computer. • Make sure any interface cables are connected securely at both ends. • If you connected your product to a USB hub, make sure it is a first-tier hub. If it still does not print, connect your product directly to your computer instead of the hub. • Make sure the printer status is not offline or pending. • Run a product check to see if a test page prints. If the test page prints, check to see if your product software is installed correctly. • Make sure your system meets the requirements for your operating system. If you are printing a high- resolution image, you may need more than the minimum requirements. Print the image at a lower resolution or if necessary, increase your system's memory. 397