Eureka SuctionSeal PET AS1104A Owner's Guide - Page 4

How to identify parts of vacuum cleaner Handle SPECIAL FEATURES Available on some models Hose Air path selector knob Power cord Cord reel Suction plates Turbo nozzle (on some models) Dust cup release Filter assembly (located inside dust cup) Dust cup Exhaust/HEPA filter compartment (located behind dust cup) Turbo Turbo cover nozzle WAND 2 Wand 2 Stair hose Crevice tool Dusting brush Cord rewind switch Height adjustment knob Brush roll cover Power switch Brush roll lever Handle release Cord clip Carry handle Wand Lower hose retainer Base hose Maintenance schedule Maintenance Schedule is also located on back side of dust cup. ! READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER. Moving parts! Power switch is marked I for On/Off. Exhaust / HEPA filter EF6 Replace within 6 months Washable dust cup filter DCF25 Clean as needed to maintain suction Washable Washable filter DCF25 NOTICE To view our instructional video, please visit www.eureka.com Lift latch and Press down tab remove dust cup. and remove filter cover. Pull filter latch to release dust cup cover. Lift out cup filter. Wash filter; allow to air dry thoroughly. Filter assembly Exhaust/HEPA filter EF6 Type S belt Brush roll 2 Eureka Customer Service HELPLINE 1-800-282-2886 Lift out filter and replace. Reinstall cover and snap into place. HEPA filter cover must be in place at all times. Remove vacuum cover for belt change instructions Lift out filter tube and screen. Shake off dust. Rinse; dry thoroughly. Remove 4 screws and lift off cover. Empty cup after each use Align tabs on filter tube, screen and cup; drop into position. Reinstall cup filter. Close cover. Filters and screen must be in place for cover to lock. Press lever to release bottom lid. Debris will empty. Close lid until it clicks. ! Periodically check hose for clogs in order to prevent air restriction. BRUSH ROLL - Clean monthly TYPE S BELT - Replace worn, cut or out of shape belt www.eureka.com