Fisher and Paykel CDV3-304H-N User Guide - Page 10

Burner use, Selecting and using burners

Get Fisher and Paykel CDV3-304H-N PDF manuals and user guides View all Fisher and Paykel CDV3-304H-N manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Selecting and using burners BURNER USE 1 Identify the desired burner and the corresponding dial. Push the dial in and turn counterclockwise to HI. Hold the dial at HI before turning to a flame setting. 2 You should hear a clicking sound when setting to HI. If no clicking sound is present, turn the dial back clockwise to OFF and refer to 'Troubleshooting' for advice. 3 When the burner is lit, turn the dial to any setting between HI (high) and SIM (simmer). When you have finished cooking, turn the dial clockwise back to OFF. 4 If you are using LP gas, there may be a slight extinction pop or flash at the flame spreader a few seconds after the burner has been turned off. This is normal. WARNING! If the flame is extinguished during a power failure, turn the dial back to OFF as the burner will not automatically relight and gas may accumulate. 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
BURNER USE
WARNING!
If the flame is extinguished during a power failure, turn the dial back to
OFF
as the
burner will not automatically relight and gas may accumulate.
Identify the desired burner and the
corresponding dial.
When the burner is lit, turn the dial to any
setting between
HI
(high) and
SIM
(simmer).
When you have finished cooking, turn the
dial clockwise back to
OFF
.
If you are using LP gas, there may be
a slight extinction pop or flash at the flame
spreader a few seconds after the burner has
been turned off. This is normal.
1
2
3
4
Selecting and using burners
Push the dial in and turn counterclockwise
to
HI.
Hold the dial at
HI
before turning to a
flame setting.
You should hear a clicking sound when
setting to
HI
. If no clicking sound is present,
turn the dial back clockwise to
OFF
and
refer to ‘Troubleshooting’ for advice.
10