Fisher and Paykel DD24DCTX7 BOOK USER DISHDRAWER PH7 (EN) (English) - Page 36
Possible Cause - standard
View all Fisher and Paykel DD24DCTX7 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
32 Troubleshooting Problem Possible Cause What to do The wash program seems to have finished (the dishwasher is idle), but the end of wash beeps haven't sounded and the drawer cannot be opened Water pooling on inner rim of drawer after a wash Water under the drain filter The wash program is still underway. It is in a 'quiet' phase that is needed for ensuring the best wash results. No action required. The program will transition into a more audible phase after the 'quiet' phase is over. This is normal condensation. If there is any water over the control buttons, wipe dry. This is normal and needs no action. Excess water in the Drain hose(s) bent or drawer kinked. Straighten the drain hose(s). Blocked filters. Clean the filter plate/drain filter. Refer to 'User maintenance instructions'. Water marks on the Rinse aid depleted. dishes Rinse aid setting too low. Refill the rinse aid dispenser. Increase the rinse aid setting. Dishwasher overloaded/ incorrectly loaded. Refer to the section on loading. Drawer interior is stained Some foods, like tomato based products, may stain the inside of the drawer. Pre-rinse dishes before placing in the drawer. Alternatively, using the Rinse program after adding the dishes may minimise staining. Dishes did not dry Incorrect loading. Ensure the dishes are not nesting together. Dishes were left in the drawer for several hours after a wash. We recommend unloading the dishes within a few hours after a wash program has finished, as the small amount of vapour left after the wash may -with time- resettle on dishes as condensation. Using rinse aid or increasing its setting may also help reduce this problem. Rinse aid depleted. Refill the rinse aid dispenser. Rinse aid setting too low. Increase the rinse aid setting. Eco wash program used. Choose a standard wash program. No detergent dispensed Detergent dispenser was wet when loaded. Clean the dispenser and ensure it is dry before adding detergent. Excessive motor noise The filter plate and/or spray Refer to the 'User maintenance instructions' arm is incorrectly placed. section for details on correct placement. No water in the motor area. This usually occurs on the first use or when the dishwasher has not been used for long periods of time. Pour 3 cups of water into the drawer before running a wash program.