Fisher and Paykel E522BRXFDU4 User Guide - Page 20
Using your water dispenser
View all Fisher and Paykel E522BRXFDU4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
18 Using your water dispenser Dispensing pad Your water dispenser has been designed for one handed operation. Simply push your glass up against the dispenser pad found at the back of the dispenser area. This pad requires only a gentle press to activate. Please remember that pressing very hard against the dispensing pad will not make the dispenser operate faster or produce greater quantities of water. First use After installation, on the first use, allow approximately a one minute delay from when the dispensing pad is pushed until water is dispensed. This will allow the tank to fill completely. The symbol will flash while the water reservoir fills up. Once the reservoir is full, the symbol will stop flashing. After you fill the tank for the first time, dispense and discard approximately 3 qt (3 L) stopping intermittently to flush the tank out. Dispensing Unless Measured Fill is selected, water will be dispensed in free-flow mode. (For more information on Measured Fill refer to page 21). To dispense water push the dispensing pad gently, using a glass or container. When you dispense water, a light will appear above the dispensing area, and on the display screen. The water fill icon will also appear. To stop the flow of water, simply pull your glass away from the dispensing pad. Fig.17 Water dispenser Important! To avoid damage to property or personal injury do not put hands, fingers or objects up the dispenser opening. Please note that once installation is complete a few drips may appear out of the dispenser over the next few days as the remaining trapped air is cleared.