Frigidaire FAQE7072LW Complete Owner's Guide (English) - Page 11

OPERATING INSTRUCTIONS Cycle Settings For best results Follow the fabric care label instructions on items to be dried. Appropriate drying Temperature, Dryness Level and Options will automatically be displayed for each cycle. The settings can be changed before the cycle is started. Drying Temperature To change the preset temperature, press the Temp button to scroll to the desired setting. To protect your fabrics, not all temperatures are available with every cycle. The temperature selected for the cycle will be remembered and recalled each time that cycle is selected in the future. To return to factory settings, press these two buttons at the same time and hold until the signal sounds. Í NOTE To change the Temperature after the cycle starts, press Pause, adjust the setting and press Start to resume the cycle. Sanitize Recommended for durable fabrics and towels. Use this selection to remove harmful bacteria from your clothing or other items where sanitization is desired. Í NOTE The Sanitize option has been certified by NSF International®, an independent third-party testing and certification organization dedicated to public health, safety and environmental protection. NSF Protolcol P154 Sanitization Performance of Residential Clothes Dryers This option will kill 99.9% of bacteria with no carryover of bacteria between loads. A higher temperatures is required. Please check fabric care labels to prevent damage. High Recommended for most cotton fabrics. Normal Recommended for wrinkle free, easy care, lightweight fabrics and bulky loads. Low Recommended for delicate fabrics. Air Dry This setting (no heat) should only be used with a Timed Dry cycle to dry items containing feathers, down, foam rubber, plastics or rubber-like materials; to refresh clothing, stuffed animal, pillows or blankets; and to dust draperies. Dry Level (Auto Dry) To change the preset level, press the Dry Level button to scroll to the degree of dryness desired. To protect your fabrics, not all dryness levels are available with every cycle. If a Dry Level is not appropriate for the cycle, it cannot be selected. The Dry Level selected for the cycle will be remembered and recalled each time that cycle is selected in the future. To return to factory settings, press these two buttons at the same time and hold until the signal sounds. Í NOTE To change the Dry Level after the cycle starts, press Pause, adjust the setting and press Start to resume the cycle. Select the Normal dry level for most Auto Dry cycles. Occasionally a load may seem too damp or over-dried at the end of the cycle. To increase drying time for similar loads in the future, select More. For loads requiring less drying time, select Less. Select Damp for items you wish to partially dry before hanging or ironing. 11