Frigidaire FCRE3062AB Complete Owners Guide - Page 22

22 SETTING OVEN CONTROLS Adjust Oven Temperature (UPO) Your appliance has been factory calibrated and tested to ensure an accurate baking temperature. For the first few uses, follow your recipe times and temperature recommendations carefully. If you think the oven is cooking too hot or too cool for your recipe times, you can adjust the control so the oven cooks hotter or cooler than the temperature displayed. Important: Do not use oven thermometers such as those found in grocery stores to check the temperature settings inside your oven. These oven thermometers may vary as much as 20 to 40 degrees from actual temperatures. The oven temperature may be increased as much as +35°F (+19°C) or decreased -35°F (-19°C) from the factory calibrated settings. To increase or decrease the oven temperature by 20°F: 1. Press . 2. Press the Up or Down arrow until "UPO" appears in the display. 3. Press START 4. Press the Up or Down arrow until the desired amount of temperature adjustment is shown. The oven temperature may be increased as much as +35°F or decreased -35°F from the factory calibrated settings. The oven temperature adjustment may be made if your oven control is set to display temperatures in °C (Celsius). Minimum and maximum settings for Celsius range from plus +19°C to minus -19°C. 5. Press START to accept change. Important note: • Oven temperature adjustments will not change the Broil, Self Clean, or Keep Warm temperatures. Restore Factory Settings (rSEt) Your appliance was set with predetermined (default) oven control settings. Over time, users may have made changes to these settings. The following options may have been modified since the appliance was new. • 12 or 24 hr display mode • Continuous bake or 12-hour energy savings mode • Silent or audible controls • Oven temperature display (Fahrenheit or Celsius) • Oven temperature adjustments (UPO) To restore oven control to factory default settings: 1. Press . 2. Press the Up or Down arrow until "rSEt" appears in the display. 3. Press and hold START for three seconds. The control has been reset with the default settings. Continuous bake setting or 12-hour energy saving feature (E-SA) The oven control has a built-in 12-hour energy saving feature that will shut off the oven if the oven is left on for more than 12 hours. The oven control can be prgrammed to override this feature for continuous baking. To change the continuous bake setting: 1. Press . 2. Press the Up or Down arrow until "E-SA" appears in the display. 3. Press START. 4. Press the Up or Down arrow to toggle between "12Hr" and "Cont. 5. Press START to accept when the desired setting is displayed.