Frigidaire FCRG3051BW Complete Owners Guide - Page 26
Cleaning the surface burners
View all Frigidaire FCRG3051BW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
26 CARE AND CLEANING Cleaning the surface burners To avoid possible burns, do not attempt cleaning before turning off all surface burners and allowing them to cool. Any additions, changes, or conversions required in order for this appliance to satisfactorily meet the application needs must be made by an authorized qualified Agency. Routinely clean the cooktop. Wipe with a clean, damp cloth and wipe dry to avoid scratches. Keeping the surface burner head ports and slots clean will prevent improper ignition and an uneven flame. To clean recessed and contoured areas of cooktop: • If a spill occurs on or in the recessed or contoured areas, blot up spill with an absorbent cloth. • Rinse with a clean, damp cloth and wipe dry. Burner Cap Burner Head Orifice Holder Ignitor CAUTION To avoid possible burns do not attempt to operate the surface burners without the burner caps. Do not use spray oven cleaner on the cooktop. To clean burner heads: 1. Remove the burner cap and the burner head (see Figure 14). Clean with hot soapy water and dry thoroughly 2. For burned-on and dried spills, apply hot soapy water to the burner head. Allow time for the soils to soften. 3. Use a toothbrush to clean all over the burner head. 4. Use a needle or fine wire to clean out the ignition port. 5. Wipe the burner head clean with a soft, clean cloth, sponge, or scratch-free cleaning pad. 6. Before using the cooktop again, make sure the burner head has fully seated back into place and the burner cap is properly seated on the burner heads. You can wiggle the cap to test placement, neither the cap nor the head should slide out of position (see "Assembly of the Burner Caps" on page 13). Figure 14: Burner cap, burner head, ignitor, and orifice Important notes: • The surface burner heads are secured to the cooktop and must be cleaned in place on the cooktop. • Always keep the surface burner caps in place whenever a surface burner is in use. • When replacing the burner caps, be sure the burner caps are seated firmly on top of the burner heads. • For proper flow of gas and ignition of burners do not allow spills, food, cleaning agents, or any other material to enter the gas orifice port opening.