Frigidaire FGBD2438PB Complete Owner's Guide (English) - Page 12

FACTORS AFFECTING PERFORMANCE Rinse Aid Rinse aid greatly improves drying, reduces water spots and filming, and lubricates wash arm bearings for proper rotations. With it, water "sheets" off dishes rather than forming water droplets that cling and leave spots. A dispenser, located next to the detergent cup, automatically releases a measured amount of rinse aid during the last rinse. If spotting and poor drying are problems, increase the amount of rinse aid dispensed by rotating the dial to a higher number. The dial is located under the dispenser cap. The indicator will be dark when full and will show clear when it is time to refill. On models with a STATUS window, LO will appear at the end of the cycle indicating that it is time to refill. To add liquid rinse aid, turn dispenser cap 1/4 turn counterclockwise and lift out. Pour in rinse aid until liquid touches the indicated fill level. Replace cap. Do not overfill since this can cause oversudsing. Wipe up any spills with a damp cloth. The dispenser holds enough for 35 to 140 washes, depending on the setting. Dispenser Opening Indicator Water Pressure The hot water line to the dishwasher must provide water pressure between 20 and 120 psi. Low water pressure may occur when laundry or showers are in operation. If you experience poor wash perfomance you may need to wait until water use is reduced before starting your dishwasher. Water Temperature Hot water is needed for best dishwashing and drying results. Water entering the dishwasher should be about 120°F (49°C) to give satisfactory results. To check water temperature entering dishwasher: • Turn on hot water faucet nearest dishwasher for several minutes to clear cool water from pipes. • Hold a candy or meat thermometer in the water stream to check the temperature. • If temperature is below 120°F (49°C), have a qualified person raise the hot water heater thermostat setting. CARE AND CLEANING WARNING Burn Hazard Allow heating element to cool before cleaning the interior. Failure to do so can result in burns. Less More Dispenser Cap Adjustable setting IMPORTANT Before starting a cycle, run hot water to clear cool water from pipe. Outside-Clean outer door with warm soapy water and a dishcloth or sponge. Rinse with clean water and a dry cloth. Do not use harsh cleaners or abrasive pads. Inside-The inside of the dishwasher is self-cleaning with normal use. If needed, clean around the tub gasket area with a damp cloth. A glass trap located in the center of the filter is designed to collect pieces of broken glass, straws, bones and pits. To remove items in glass trap, grasp handle, rotate, lift out, empty and replace. 12