Frigidaire FGDS3065KF Complete Owner's Guide (English) - Page 9

before setting surface controls Control locations of the gas surface burners Your built-in range is equipped with gas surface burners with different BTU ratings. The ability to heat food quicker and in larger volumes increases as the burner size increases. The small simmer burner is best used for simmering delicate sauces, etc. This burner is located at the right rear burner position on the cooktop (see Figures 1 & 2). The standard burner can be used for most surface cooking needs. The standard burners are located at the left front position on the cooktop (see Figures 1 & 2). The power burners are best used for bringing large quantities of liquid rapidly up to temperature or when preparing larger quantities of food. The POWER burners are located at the right front and left rear burner positions on the cooktop (see Figures 1 & 2). Regardless of size, always select cookware that is suitable for the amount and type of food being prepared. Select a burner and flame size appropriate to the pan. Never allow flames to extend beyond the outer edge of the pan. Figure 2 - Model B Assembly of the surface burner caps and burner grates It is very important to make sure that all of the Surface Burner Caps and Surface Burner Grates are installed correctly and at the correct locations. 1. Remove all packing material from cooktop area. 2. Discard all packing material (if applicable). 3. Unpack Burner Grates and position on the cooktop. REMEMBER - DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING. Always keep the Burner Caps and Burner Heads in place whenever the surface burners are in use. Figure 1 - Model A 9