Frigidaire FPES3085KF Complete Owner's Guide (English) - Page 31

SETTING OVEN CONTROLS SETTING the Sabbath Feature (for use on the Jewish Sabbath & Holidays) The BAKE TIME and DELAY START pads are used to set the Sabbath feature. The Sabbath feature may only be used with the BAKE pad. The oven temperature may be set higher or lower after setting the Sabbath feature (the oven temperature adjustment feature should be used only during Jewish Holidays), however the display will not visibly show or provide any audible tones indicating whether the change occurred correctly. Once the oven is properly set using Bake with the Sabbath feature active, the oven will remain continuously ON until cancelled. This will override the factory preset 6-Hour Energy Saving feature. If the oven light will be needed during the Sabbath, press OVEN LIGHT before activating the Sabbath feature. Once the oven light is turned ON and the Sabbath feature is active, the oven light will remain ON until the Sabbath feature is turned OFF. If the oven light needs to be OFF, be sure to turn the oven light OFF before activating the Sabbath feature. To Program the Oven to Begin Baking Immediately & activate the Sabbath feature (example: baking at 350°F) 1. Be sure that the clock is set with the correct time of day. 2. Place the food in the oven. 3. Press BAKE. "350°" appears in the display. 4. Press START. The actual oven temperature appears in the display. 5. If you desire to set the oven control for a Bake Time or Delayed Bake Time do so at this time. If not, skip this step and continue to step 7. Refer to the Bake Time / Delay Start section for complete instructions. Remember the oven will shut down after using Bake Time or Delay Start and therefore may only be used once during the Sabbath/Jewish Holidays. 6. The oven will turn ON and begin heating. 7. Press and hold both the BAKE TIME and DELAY START pads for at least 3 seconds. "SAb" will appear in the display. Once "SAb" appears in the display the oven control will no longer beep or display any further changes and the oven is properly set for the Sabbath feature. 8. The oven may be turned OFF at any time by first pressing CANCEL pad (this will turn the oven OFF only). To turn OFF the Sabbath feature press and hold both the BAKE TIME and DELAY START pads for at least 3 seconds. "SAb" will disappear from the display. IMPORTANT It is not advised to attempt to activate any other program feature other than BAKE while the Sabbath feature is active. ONLY the following key pads will function after setting the Sabbath feature; 0 to 9, BAKE, START & CANCEL. All other keypads should not be used once the Sabbath feature is properly activated.  NOTE You may change the oven temperature once baking has started by pressing BAKE, the numeric key pads for the temperature you want (example for 425°C press 4 2 5) and then pressing START twice (for Jewish Holidays only). Remember that the oven control will no longer beep or display any further changes once the oven is set for the Sabbath feature. Should you experience a power failure or interruption, the oven will shut off. When power is returned, "SF" (Sabbath Failure) will be shown in the oven display and the cooktop displays (models B & C). The oven and cooktop will not turn back on automatically. If your food was nearly fully cooked, you may allow the trapped heat in the oven to finish the cooking process. Otherwise, you should remove the food when the power failure occurs, because you may only start the oven once during the Sabbath/Jewish Holidays. After the Sabbath observance, turn OFF the Sabbath feature and be sure that all the control knobs are at the OFF position. The appliance may be used again with all normal functions. After the Sabbath observance turn OFF the Sabbath feature. Press and hold both the BAKE TIME and DELAY pads for at least 3 seconds. "SAb" will disappear from the display and the oven may be used with all normal functions. For further assistance, guidelines for proper usage, and a complete list of models with the Sabbath feature, please visit the web at http:\\www.star-k.org. How the Electronic Surface Element Controls work when the Sabbath feature is ON. (model B & C only) When your Oven Sabbath feature is ON, the Electronic Surface Elements are also in Sabbath mode. This means that all electronic surface element control displays show "Sb". The surface elements can be used even if the Sabbath Feature is on. To turn ON a Surface Element when the Oven Sabbath Feature is active: If you turn on a surface element when the oven Sabbath feature is on, the electronic surface element control will record that request and execute it with a 15-30 seconds delay. So the element will start heating 15-30 seconds after the surface element control was turned on. As the oven control, the surface element display will not show the setting because "Sb" is on in the displays. When necessary, it is possible to adjust the power of the surface element but you have to remember that the surface element control will adjust the temperature with the same delay. To turn OFF the Surface Element when the Oven Sabbath Mode is active: To shut off the surface element while the Sabbath feature is ON, proceed as usual but take note that the element will immediately turn off without any delay. 31