Fujitsu S7110 S7110 User's Guide - Page 73

S7110.book Page 63 Monday, March 20, 2006 1:56 PM Troubleshooting Problem Possible Cause Possible Solutions The Suspend/Resume button does not work. There may be a conflict with Close all applications and try the button again. the application software. (continued) The system powers up, and displays power on information, but fails to load the operating system. The boot sequence settings of the setup utility are not compatible with your configuration. Set the operating source by pressing the [ESC] key while the Fujitsu logo is on screen or use the [F2] key and enter the setup utility and adjust the source settings from the Boot menu. (See BIOS Setup Utility on page 29 for more information) You have a secured system requiring a password to load your operating system. Make sure you have the right password. Enter the setup utility and verify the Security settings and modify them as accordingly. (See BIOS Setup Utility on page 29 for more information) Internal hard drive was not detected. Use the BIOS setup utility or Primary Master submenu, located within the Main menu, to try to auto detect the internal hard drive. An error message is displayed on the screen during the notebook (boot) sequence. Power On Self Test (POST) has detected a problem. See the Power On Self Test (POST) messages to determine the meaning and severity of the problem. Not all messages are errors; some are simply status indicators. (See Power On Self Test Messages on page 66 for more information) Your notebook appears to change setup parameters when you start it. BIOS setup changes were not saved when you made them and exited the BIOS setup utility returning it to previous settings. Make sure you select Save Changes And Exit when exiting the BIOS setup utility. The BIOS CMOS hold-up battery has failed. Contact your support representative for repairs. This is not a user serviceable part but has a normal life of 3 to 5 years. Your system display won't turn on when the system is turned on or when the system has resumed. The system may be passwordprotected. Check the status indicator panel to verify that the Security icon is blinking. If it is blinking, enter your password. Video Problems The built-in display is blank when you turn on your LifeBook notebook. Something is pushing on the Closed Cover switch. The notebook is set for an external device only. Clear the Closed Cover switch. (See figure 2-4 on page 6 for location) Pressing [F10] while holding down the [Fn] key allows you to change your selection of where to send your display video. Each time you press the combination of keys you will step to the next choice. The choices, in order are: built-in display only, external monitor only, both built-in display and external monitor. The angle of the display and the brightness settings are not adequate for your lighting conditions. Move the display and the brightness control until you have adequate visibility. 63