Fujitsu fi-5530C Operator's Guide - Page 22
Placing Documents on the ADF
UPC - 097564306778
View all Fujitsu fi-5530C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
1.2 Placing Documents on the ADF For details about paper sizes and paper materials for the ADF to work HINT properly, refer to Chapter 6 "DOCUMENT SPECIFICATIONS FOR ADF" (page 131). 1. Align the edges of sheets in the document. 1) Confirm that all sheets have the same width. 2) Check the number of the sheets in the document stack. The standard number of sheets that can be loaded on the scanner is as follows: • A4-size paper or smaller that makes a document stack of 10 mm or less (100 sheets at 80 g/m2 or at 20 lb) • Over A4-size paper that makes a document stack of 5 mm or less (50 sheets at 80 g/m2 or at 20 lb) 2. Fan the sheets as follows: 1) Lightly hold the both ends of the stack with both hands, and bend it as shown in the figure below. 2) Hold the stack firmly with both hands and bend them back so that the bent section rises up in the middle of the stack as shown in the figure below. 3) Repeat steps 1) and 2) a couple of times. 4) Rotate the document 90 degrees, and fan the stack again. 3. Align the top of the sheets. 6