Fujitsu fi 5750C Operator's Guide - Page 28
Setting the ADF - flatbed scanner
View all Fujitsu fi 5750C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Introduction CONTENTS 1 NAMES AND FUNCTIONS OF PARTS 2 BASIC SCANNER OPERATION 2.1 Turning the scanner ON/OFF 2.2 Setting the ADF 2.3 Loading documents onto the ADF 2.4 Scanning document using the Flatbed 2.5 Scanning documents 2.6 How to use the Scanner Driver 3 SCANNING VARIOUS TYPES OF DOCUMENTS 4 DAILY CARE 5 REPLACING CONSUMABLES 6 TROUBLESHOOTING 7 ONLINE SETUP 8 DOCUMENT SPECIFICATION OF ADF 9 OPTIONS 10 SCANNER SPECIFICATIONS Appendix 2.2 Setting the ADF Follow the procedure below to set or change the position of the ADF. As the factory default, ADF of fi-5750C is fixed with ADF lock screws. Be sure to remove the screws before changing the position of the ADF. ADF can be set to the following three positions: q Type 1: Traditional -Traditional style of previous FUJITSU scanner products -For operators accustomed to previous FUJITSU scanners q Type 2: Standard - Small foot print - For right-handed operators q Type 3: Reversed - Small foot print - For left-handed operators ATTENTION q Please rotate the ADF after you set the stacker upright. q When you change the position of the ADF, do not rotate it over 180 degrees, otherwise the ADF may be damaged. q Make sure that the ADF is firmly locked when you changed its position. CAUTION q Be careful not to pinch your fingers with the ADF . All Rights Reserved, Copyright (C) PFU LIMITED 2003