Garmin Edge Explore 2 Instructions - Page 4
Installing the Edge Power Mount, If the handlebar diameter is 25.4 mm, use the thicker pad.
View all Garmin Edge Explore 2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Installing the Edge Power Mount You can use the power mount to install your Edge device and connect it to your eBike. Garmin recommends that you adjust the mount for the Edge viewing angle before you connect the cable to your eBike. 1 Select a secure location to mount the Edge device where it does not interfere with the safe operation of your eBike. 2 Use the 2.5 mm hex key to remove the screw from the handlebar connector . 3 Place a rubber pad around the handlebar: • If the handlebar diameter is 25.4 mm, use the thicker pad. • If the handlebar diameter is 31.8 mm, use the thinner pad. 4 Place the handlebar connector around the rubber pad. NOTE: You should align the contours on the rubber pad with the grooves on the inside of the handlebar connector. 4 Installation Instructions