Garmin TB 10 Dog Device Owner's Manual - Page 6

Device Information Pro Trashbreaker Handheld Device Specifications Battery type Battery life Operating temperature range Charging temperature range Storage temperature range Water rating Wireless range Rechargeable, replaceable lithium-ion 60 hours typical use From -4° to 140°F (from -20° to 60°C) From 32° to 104°F (from 0° to 40°C) From -4° to 104°F (from -20° to 40°C) IEC 60529 IPX7* 4 mi. (6. 4 km) *The device withstands incidental exposure to water of up to 1 meter for up to 30 minutes. Pro Trashbreaker Dog Collar Device Specifications Battery type Battery life Operating temperature range Charging temperature range Storage temperature range (up to 1 month) Storage temperature range (up to 3 months) Water rating Rechargeable, replaceable lithium-ion 40 hours typical use From -4° to 140°F (from -20° to 60°C) From 32° to 104°F (from 0° to 40°C) From -4° to 122°F (from -20° to 50°C) From -4° to 95°F (from -20° to 35°C) Up to 1 ATM* *The device withstands pressure equivalent to a depth of 10 meters. Checking the Battery Level Turn on the dog collar device (Turning On the Dog Collar Device). The status LED flashes every few seconds while the device is on. The color of the status LED indicates the battery charge level. Green The battery has a good charge. Yellow The battery should be charged soon. Red The battery is very low and should be charged immediately. Flashing Red The battery is depleted and must be charged. Training features are disabled. Replacing the VHF Antenna in the Dog Collar Device Before you replace the VHF antenna, you must remove all dirt, water, and debris from the device. You also need a small Phillips screwdriver and a larger Phillips screwdriver. 1 Remove the three screws from the cover over the VHF À antenna. 2 Pry off the cover. 4 3 Remove the screw securing the VHF antenna to the back plate. Á 4 Pull the length of the antenna from the antenna guide to remove the old antenna. 5 Loop the antenna guide around the collar strap, and thread the new VHF antenna through the guide. This helps to point the antenna up. 6 Replace the screw securing the VHF antenna to the back plate. 7 Replace the cover over the VHF antenna. 8 Replace the three screws on the cover. Pro Trashbreaker Battery Replacement Instructions WARNING This product contains a lithium-ion battery. To prevent the possibility of personal injury or product damage caused by battery exposure to extreme heat, store the device out of direct sunlight. Do not use a sharp object to remove batteries. CAUTION Contact your local waste disposal department to properly recycle the batteries. Pro Trashbreaker Handheld Device Components Security screws À Back plate Á Battery plate screws  Gasket à Battery plate Ä Battery Å Replacing the Pro Trashbreaker Handheld Device Battery Before you replace the battery, you must remove all dirt, water, and debris from the device. You also need a small Phillips screwdriver and the security screwdriver included with the battery replacement kit. You can purchase a replacement battery at http: / / buy .garmin .com. You should use only an official Garmin® replacement part. 1 Remove the eight security screws from the back of the device. 2 Lift up the back plate. 3 Grip the battery connector wires close to the connector, and pull the connector perpendicular to the circuit board to disconnect the battery connector from the device. Device Information