Garmin iQue M3 Quick Reference Guide - Page 17

Mount the iQue M3 Pivoting joint rotates to the left or right Suction cup Adjusting knobs Suction lever Cradle To install the suction mount: 1. Loosen the adjusting knobs (shown above). Then extend the mount and retighten the knobs. 2. Clean and dry the windshield and the suction cup with rubbing alcohol. 3. Make sure the suction lever is up (pulled away from the suction cup). Position the suction mount on your windshield. Press the suction cup firmly against the glass and rock it to remove as much air as possible. 4. Press the suction lever down toward the windshield. 5. Gently slide the iQue M3 down into the cradle until it clicks into place. 6. Loosen the adjustment knobs and re-position the mount, if necessary. Then tighten the knobs firmly. To remove the suction mount from the windshield, pull the suction lever up away from the windshield. If necessary, pull the tab on the bottom of the suction cup toward you. Contact Garmin If you encounter any difficulty while using your iQue M3, or if you have any questions, in the U.S.A. contact Garmin Product Support at 913/397.8200 or 800/800.1020, Monday-Friday, 8 AM-5 PM Central Time; or by e-mail at [email protected]. In Europe, contact Garmin (Europe) Ltd. at 44/0870.8501241. iQue M3 Quick Reference Guide 17