Gateway DX4710 8513028 - Gateway Hardware Reference Guide - Page 49
Adding or replacing an optical, disc drive
View all Gateway DX4710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
www.gateway.com Adding or replacing an optical disc drive Tools You need a Phillips screwdriver to add or replace an optical drive. To add replace an optical drive: 1 Remove the front bezel by following the instructions in "Removing the front bezel" on page 37. 2 If you are installing a new drive (not replacing an old one), remove the two drive retention screws in the drive bay, then go to Step 7. For the location of the screws, see the photo in Step 5. Important The color and shape of your replacement drive's front cover may vary from your original drive. 3 If you are replacing an existing drive, disconnect the cables from the drive, noting their locations and orientation. You will reconnect the cables after you install the new drive. Drive data cable Drive power cable 4 Note any jumper settings on the old drive and set the jumper on the new drive to be the same. 43