GE GFDS175EHDG Use and Care Manual - Page 11
Installation Instructions
View all GE GFDS175EHDG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Installation Instructions 1 REMOVE THE DOOR ASSEMBLY A. Open the door to approximately 130 degrees. 2 REMOVE HINGE AND COVER IMPORTANT: Note the location of the hinge (left or right) before removing. A. Remove the 6 machine screws from the hinge and the 2 machine screws from the hinge cover. Hinge Cover B. Remove the 6 tapping screws located around the perimeter of the door outlining the gasket. Remove the outer ring. Hinge B. With the screws removed, turn the door over and separate the outer door assembly and hinge cover of the door from the door frame and set aside. Hinge Cover C. Remove 3 hinge screws starting at the bottom and move up. Make sure the door is supported while removing the screws. Hinge 3 REINSTALL HINGE ASSEMBLY A. Place the hinge in the opposite side of the door as shown. Push the hinge in place until the hinge holes align with the door holes. Then loosen top screw, remove door and remove screw First remove three lower hinge screws D. Loosen the top screw as shown. Unhook the door by lifting and pulling. Remove the top screw. 11 Hinge shown on opposite side