GE GTH21KBXBB Use and Care Manual - Page 22
Transfer Bottom Hinge, Bracket To The Left, Remove Refrigerator Door, Transfer Top Hinge To,
UPC - 084691176206
View all GE GTH21KBXBB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Installation Instructions REVERSING THE DOOR SWING (CONT.) 1 REMOVE FREEZER DOOR Tape the door shut with masking tape. 3 TRANSFER TOP HINGE TO THE LEFT Interchange hinge and screws at top right with screws at the top left of cabinet. Do not tighten screws on hinge side at this time. Remove the hinge cover on top of the freezer door. Remove the four screws with a 5/16″ socket and ratchet, then lift the hinge straight up to free the hinge pin from the socket in the top of the door. Top Hinge Remove the tape and tilt the door away from the cabinet. Lift it off the center hinge pin. NOTE: Do not misplace the washer located on the top side of the center hinge pin. Set the door on a non-scratching surface with the inside up. 2 REMOVE REFRIGERATOR DOOR Tape the door shut with masking tape. Remove the center hinge by removing two hinge screws with a 5/16″ socket and ratchet. Lift the hinge pin up and out of the door. NOTE: Do not misplace the washer located on the underside of the center hinge pin. Plastic Washer Hinge Pin Center Hinge Bracket 4 TRANSFER BOTTOM HINGE BRACKET TO THE LEFT For models with a base grille, remove it by grasping it about 6″ from each end and pulling its bottom edge toward you. Using a 5/16″ socket and ratchet, remove the 3 screws from the bottom hinge. Taking care not to misplace the washer on the bottom hinge, move the bottom hinge from the right to the left side. NOTE: If the washer is not on the hinge bracket, check to see if it is stuck to the bottom of the door. Plastic Washer Hinge Bracket Replace the base grille by inserting the tops of the metal clips into the oval vents, making sure one of the plastic tabs on the back of the grille goes into each of the oval vents. Then push the bottom of the grille forward until it snaps into place. Fresh Food Door Remove the tape and tilt the door away from the cabinet. Lift the door straight up to free its bottom socket from the pin in the bottom hinge bracket. Set the door on a non-scratching surface with the inside up. CAUTION: Do not let door drop to the floor. To do so could damage the door stop. 22