GE GTS18JCPCC Use and Care Manual - Page 15
Transfer Bottom Hinge, Bracket To The Left, Remove Refrigerator Door, Transfer Top Hinge To,
UPC - 084691080282
View all GE GTS18JCPCC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Installation Instructions 1 REMOVE FREEZER DOOR Tape the door shut with masking tape. Top Hinge 3 TRANSFER TOP HINGE TO THE LEFT Interchange hinge and screws at top right with screws at the top left of cabinet. Do not tighten screws on hinge side at this time. Remove the hinge cover on top of the freezer door (on some models). Remove the two Torx® screws, then lift the hinge straight up to free the hinge pin from the socket in the top of the door. Remove the tape and tilt the door away from the cabinet. Lift it off the center hinge pin. Set the door on a non-scratching surface with the inside up. 2 REMOVE REFRIGERATOR DOOR Tape the door shut with masking tape. Remove the center hinge pin with a 3/8″ socket and ratchet. Plastic Washer Hinge Pin Center Hinge Bracket 4 TRANSFER BOTTOM HINGE BRACKET TO THE LEFT For models with a base grille, remove it by grasping it about 6″ from each end and pulling its bottom edge toward you. Using a Torx® driver, move the bottom hinge bracket and plastic washer from the right side to the left side. NOTE: If the washer is not on the hinge bracket, check to see if it is stuck to the bottom of the door. Plastic Washer Hinge Bracket For models with a base grille, before replacing the base grille, remove the grille cap by removing the screw. Screw the cap to the opposite side. Fresh Food Door Remove the tape and tilt the door away from the cabinet. Remove and save the washer on the hinge pin. Lift the door straight up to free its bottom socket from the pin in the bottom hinge bracket. Set the door on a non-scratching surface with the inside up. CAUTION: Do not let door drop to the floor. To do so could damage the door stop. Replace the base grille by inserting the tops of the metal clips into the oval vents, making sure one of the plastic tabs on the back of the grille goes into each of the oven vents. Then push the bottom of the grille forward until it snaps into place. 15