GE GTX22EASKWW Installation Instructions - Page 15

Installation Instructions SIDE OR BOTTOM VENTING Dryer Exhaust to right of cabinet for Electric models only. Dryer Exhaust to left of cabinet for Gas and Electric models. Dryer Exhaust to the bottom of cabinet for Gas and Electric models. WARNING - Fire Hazard Close the back opening with cover plate (Kit WE1M454). Disconnect dryer from electrical supply. Wear gloves and arm guards. Failure to do so may result in fire, electrical shock or lacerations. Right (electric models only) Remove screw and save Left Bottom Remove desired knockout (one only) Detach and remove the right (electric models only), left or bottom knockout as desired. Remove the screw inside the dryer exhaust duct and save. Pull the duct out of the dryer. Fixing hole A 9-1/2" (24.13cm) For models GTD60, GTD65 and GTD68 only, use the dimension below. Fixing hole TAB LOCATION Not for gas BEND TAB UP 45 o Through the rear opening, locate the tab in the middle of the appliance base. Lift the tab to about 45°, using a flat-blade screwdriver. ADDING A NEW DUCT Fixing hole Portion "A" Right Right (electric models only) or left side exhaust Left Reconnect the cut portion (A) of the duct to the blower housing. Make sure that the shortened duct is aligned with the tab in the base. Use the screw saved previously to secure the duct in place through the tab on the appliance base. ADDING ELBOW AND DUCT FOR EXHAUST TO SIDE OF CABINET Right Exhaust can be added to right (electric models only) or left side Right Left Duct tape Left A 10-1/2" (26.67cm) Cut the duct as shown and keep portion A. • Preassemble 4" elbow with 4" duct. Wrap duct tape around joint. • Insert duct assembly, elbow first, through the side opening and connect the elbow to the dryer internal duct. Be sure not to pull or damage the electrical wires inside the dryer when inserting the duct. 15