GE JB968 Owners Manual - Page 36

Consumer Support Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions Care and cleaning of the range. Wire cover holder. Oven Light Replacement CAUTION: Before replacing your oven light bulb, disconnect the electrical power to the range at the main fuse or circuit breaker panel. Be sure to let the light cover and bulb cool completely. To remove the cover: Hold a hand under the cover so it doesn't fall when released. With fingers of the same hand, firmly push back the wire cover holder. Lift off the cover. Do not remove any screws to remove the cover. Replace bulb with a 40-watt appliance bulb. To replace the cover: Place it into groove of the light receptacle. Pull wire forward to the center of the cover until it snaps into place. Connect electrical power to the range. Stop guide Rail Storage Drawer Removal (on some models) To remove the drawer: To replace the drawer: Pull the drawer out until it stops. Place the drawer rails on the guides. Lift the front of the drawer until the stops clear the guides. Remove the drawer. Push the drawer back until it stops. Lift the front of the drawer and push back until the stops clear the guides. Lower the front of the drawer and push back until it closes. Oven Heating Elements Do not clean the broil element. Any soil will burn off when the element is heated. Clean the oven floor with warm, soapy water. On some models, the bake element is not exposed and is under the oven floor. If spillovers, residue or ash accumulate on the oven floor, wipe up before self-cleaning. Wipe up heavy soil on the oven bottom. 36