GE JVM2070WH Installation Instructions - Page 17
ADAPTING MICROWAVE, BLOWER FOR OUTSIDE, BACK EXHAUST cont., NOTE: The blower unit exhaust
View all GE JVM2070WH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Installation Instructions B5. ADAPTING MICROWAVE BLOWER FOR OUTSIDE BACK EXHAUST (cont.) 3 Roll the blower unit 90° so that fan blade openings are facing the front of the microwave. Before Rolling After Rolling 7 Guide the wire down into the blower opening so it rests securely in front of the blower. Back of Microwave Back of Microwave 4 Gently slip the wire through the gap between the two tabs on the top of the blower so the wire is behind the tabs. Before Rerouting After Rerouting 8 Secure the blower unit to the microwave with the screw from Step 1. Blower Plate Back of Microwave Blower Motor Screw 5 Rotate blower unit counterclockwise 180°. Before Rotation After Rotation Back of Microwave Back of Microwave 6 Place the blower unit back into the opening. AFTER: Fan Blade Openings Facing Back End A End B 9 Replace the blower plate in the same position as before with the screw. 10 Attach the exhaust adaptor to the rear of the oven by sliding it into the guides at the top center of the back of the oven. Adaptor Back of Microwave Guide Guide CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. NOTE: The blower unit exhaust openings should match exhaust openings on rear of microwave oven. 17