GE JVM2070WH Installation Instructions - Page 20
Check Microwave Assembly, Adapting Microwave Blower for Recirculation, AFTER: Fan Blade
View all GE JVM2070WH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Installation Instructions C3. CHECK MICROWAVE ASSEMBLY Exhaust Adaptor (absent on models shipped for recirculation exhaust) 5 Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit. Back of Microwave • Place the microwave in its upright position, with the top of the unit facing up. • The microwave oven may be shipped assembled for top exhaust (adaptor installed) or for recirculation exhaust (adaptor absent). • If the microwave was shipped for recirculation exhaust, skip to C5. If shipped for top exhaust, proceed with C4. C4. ADAPTING MICROWAVE BLOWER FOR RECIRCULATION 1 Remove and save screw that holds blower plate to microwave. Damper 2 Lift off the blower plate and attached adaptor from the microwave. Back of Microwave 3 Slide exhaust adaptor to one side and remove it. NOTE: The exhaust adaptor with damper is not needed for recirculating models. You may want to save them for possible future use. 6 Roll the blower unit 90° so that fan blade openings are facing toward the front of the microwave. Roll BEFORE: Fan Blade Openings Facing Up AFTER: Fan Blade Openings Facing Forward 7 Place the blower unit back into the opening. CAUTION: Do not pull or stretch the blower unit wiring. Make sure the wires are not pinched. 4 Remove and save the screw that holds the blower motor to the microwave. Blower Plate Back of Microwave Blower Motor Screw 20