GE JVM3160RFSS Installation Instructions - Page 17

Installation Instructions B2 USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and a cutout large enough for the exhaust adaptor. B3 $'-867%/2:(502725FRQW Rotate 90° Back of Mircrowave 3 Roll the blower so that fan blade openings are facing the top of the oven. Place the blower back into the opening. Fan Blades ‡ Read the instructions on the TOP CABINET TEMPLATE. ‡ Tape it underneath the top cabinet. ‡ Drill the holes, following the instructions on the TOP CABINET TEMPLATE. CAUTION::HDUVDIHW\JRJJOHVZKHQ GULOOLQJKROHVLQWKHFDELQHWERWWRP B3 ADJUST BLOWER MOTOR 1 Remove the screws holding the blower unit and the screws securing the blower plate. Remove the blower plate from the outer case by sliding it toward the back of the microwave and pulling up. Blower Motor Screws Blower Plate Wires Back of Mircrowave Note: Make sure the wires remain routed through the openings in the motor frame. To avoid damage to the fan motor wiring, insert motor carefully such that the fan motor wiring does not contact the microwave power cord bracket. WARNING: 5LVNRI(OHFWULF6KRFN Can cause injury or death. Do not pull or stretch the EORZHUXQLWZLULQJ0DNHVXUHWKHZLUHVDUHQRW pinched. 4 Slide the blower plate back onto the microwave by placing the side tabs into the slots and pushing gently until the back tab is seated into the rear slot. Replace 3 screws. Blower Motor Screw 2 Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit. Side Tab Side Slot 17 Rear Tab Rear Slot