GE PDS20MFWCC Owners Manual - Page 18
Installation Instructions, INSTALLING THE REFRIGERATOR, TO THE HOUSE WATER LINE, cont.
View all GE PDS20MFWCC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Installation Instructions INSTALLING THE REFRIGERATOR (cont.) 1 CONNECTING THE REFRIGERATOR TO THE HOUSE WATER LINE (cont.) A If you are using copper tubing, place a compression nut and ferrule (sleeve) onto the end of the tubing coming from the house cold water supply. If you are using the GE SmartConnect™ tubing, the nuts are already assembled to the tubing. B If you are using copper tubing, insert the end of the tubing into the refrigerator connection, at the back of the refrigerator, as far as possible. While holding the tubing, tighten the fitting. If you are using GE SmartConnect™ tubing, insert the molded end of the tubing into the refrigerator connection, at the back of the refrigerator, and tighten the compression nut until it is hand tight. Then tighten one additional turn with a wrench. Overtightening may cause leaks. C Fasten the tubing into the clamp provided to hold it in position. You may need to pry open the clamp. One of the illustrations below will look like the connection on your refrigerator. Icemaker-Ready models 1/4″ Copper Tubing Tubing Clamp SmartConnect™ Tubing Icemaker-Installed Models Refrigerator Connection Ferrule (sleeve) SmartConnect™ Tubing 1/4″ Compression Nut 1/4″ Compression Nut Ferrule (sleeve) Refrigerator Connection 1/4″ Tubing 2 TURN ON THE WATER SUPPLY (icemaker and dispenser models) Turn the water on at the shutoff valve (house water supply) and check for any leaks. 3 PLUG IN THE REFRIGERATOR On models with an icemaker, before plugging in the refrigerator, make sure the icemaker power switch is set to the O (off) position. See the grounding information attached to the power cord. 4 PUT THE REFRIGERATOR IN PLACE Move the refrigerator to its final location. Tubing Clamp 18