GE PSB1200NWW Installation Instructions - Page 12

Installation Preparation Preparation WITH an Accessory Storage Drawer NOTE: MODEL ZSC1201 CAN ONLY BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER IF INSTALLED ABOVE 36-3/4″. MODEL ZSC1202 CANNOT BE INSTALLED WITH AN ACCESSORY STORAGE DRAWER. SEE INSTALLATION PREPARATION WITHOUT AN ACCESSORY STORAGE DRAWER FOR THIS MODEL. PREPARE THE OPENING (cont.) Installation beside another GE/Monogram Built-in Speedcook Oven: • If you are mounting one Under-the-Counter GE/Monogram oven beside the other, use the dimensions shown. The middle rail separating the two openings may need to be larger than the 4-1/2″ minimum shown. 23-1/2″ 25-1/4″ 21″ 25-1/4″ 21″ 4-1/2″ Min. (5-1/2″ Recommended) PREPARE THE OPENING (cont.) Installation under a GE Profile 30″ or 36″ Cooktop or Countertop: Gas or electric cooktops may be installed over this oven. See cooktop installation instructions for the cutout size. See the label on top of the oven for approved cooktop models. This oven requires a separate, properly grounded 15-Amp, 120-Volt, 60Hz power supply. The cooktop requires a separate power supply. Use a 36″ or wider base cabinet. IMPORTANT: For Profile models only. The Monogram oven and drawer combination cannot be installed below a countertop. 23-1/2″ Cooktop Cooktop 25-1/4″ 21″ 1-1/2″ Min. 25″ 36″ Countertop Height Cooktop height including depth of electrical box on some models. Refer to cooktop installation instructions. No minimum clearance required between cooktop and oven. 4″ High Toekick NOTE: The oven is only approved to be installed under the specific models as labeled on the unit. 12