GE PSCS3RGXSS Installation Instructions - Page 14

Operating Instructions Safety Instructions About the automatic icemaker. A newly installed refrigerator may take 12 to 24 hours to begin making ice. On dispenser models, to access ice or reach the power switch: Lift the bin, then pull it forward until the bin stops. Lower the bin to access ice or reach the power switch. NOTE: In order to take full advantage of the tilt-out ice bin, only store items on the shelf below the ice bin that are no taller than the lowest point on the bin. Automatic Icemaker The icemaker will produce seven cubes per cycle-approximately 100-130 cubes in a 24-hour period, depending on freezer compartment temperature, room temperature, number of door openings and other use conditions. If the refrigerator is operated before the water connection is made to the icemaker, set the power switch in the OFF position. When the refrigerator has been connected to the water supply, set the power switch to the ON position. The icemaker will fill with water when it cools to 15°F (-10°C). A newly installed refrigerator may take 12 to 24 hours to begin making ice cubes. You will hear a buzzing sound each time the icemaker fills with water. Throw away the first few batches of ice to allow the water line to clear. Be sure nothing interferes with the sweep of the feeler arm. When the bin fills to the level of the feeler arm, the icemaker will stop producing ice. It is normal for several cubes to be joined together. If ice is not used frequently, old ice cubes will become cloudy, taste stale and shrink. Special note about dispenser models: ■ Dispenser models have a tilt-out ice bin. The bin can be tilted out as shown in the illustrations, and it will hold itself up while you take ice out or turn the icemaker power switch on and off. Be sure to put the bin back in place before closing the door. ■ To restore your ice level from an empty bucket stage, the following steps are recommended: 12 hours after the first batch of ice has fallen into the bin, dispense 3 to 4 cubes. After an additional 6 hours, dispense 3 to 4 cubes again. These steps will restore your ice level in the shortest amount of time. Icemaker Power Switch Feeler Arm NOTE: In homes with lower-than-average water pressure, you may hear the icemaker cycle multiple times when making one batch of ice. Lift the bin, then pull it forward until the bin stops. Removing Ice Bin (dispenser models) CAUTION: The ice bin is heavy when full. Set the power switch to the OFF position before removing the bin. When replacing the bin, be sure to press it firmly into place. If it does not go all the way back, remove it and rotate the drive mechanism 1/4 turn. Then push the bin back again. Rotate Drive Mechanism Dispenser Models only Installation Instructions Consumer Support Troubleshooting Tips Lift and pull forward again to remove the bin. 14