GE PT9050SFSS Installation Instructions - Page 3

Cutout For Double Ovens, Thermal Ovens, Cutout For Installation Over A Warming Drawer

Get GE PT9050SFSS PDF manuals and user guides View all GE PT9050SFSS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 3 highlights

2 C CUTOUT FOR DOUBLE OVENS (2 THERMAL OVENS) NOTE: If the cabinet does not have a front frame and the sides are less than ¾" (1.9 cm) thick, shim both sides equally to establish the cutout Hwidth. Junction B Box Location (junction box may be located in adjacent cabinet) F D J C G E Cutout Depth 23-1/2" K (59.7 cm) Min. A Dim. Description A Cabinet Width B Cutout Width C Cutout Height D Overlap of Oven Over Side Edges of Cutout E Clearance to Adjacent Corners, Drawers, Walls, etc., When Door Is Open F Overlap of Oven Top of Cutout G Overlap of Oven Bottom of Cutout H Junction Box Location J Height to Bottom of Junction Box K Recommended Cutout Location from Floor Continue to Section 3. 27" Double Oven 27" (68.6 cm) 25" (63.5 cm) min. 251⁄4" (64.1 cm) max. 4911⁄16" (126.2 cm) min. 501⁄8" (127.3 cm) max. 1" (2.5 cm) 23" (50.8 cm) min. 1" (2.5 cm) min. 1" (2.5 cm) min. 83⁄4" (22.2 cm) max. right side only 44" (111.8 cm) 131⁄4" (33.7 cm) 30" Double Oven with Pedestal 30" (76.2 cm) 281⁄2" (72.4 cm) min. 285⁄8" (72.7 cm) max. 5113⁄16" (131.6 cm) min. 5115⁄16" (131.9 cm) max. 11⁄16" (1.75 cm) 23" (53.3 cm) min. 1" (2.5 cm) min. (11⁄4" (3.2 cm) for PT9550) 11⁄4" (3.2 cm) 91⁄2" (24.1 cm) max. right side only 47" (119.4 cm) 12" (30.5 cm) 30" Double Oven without Pedestal 30" (76.2 cm) 281⁄2" (72.4 cm) min. 285⁄8" (72.7 cm) max. 50 ¼" (127.64cm) 11⁄16" (1.75 cm) 23" (53.3 cm) min. 1" (2.5 cm) min. (11⁄4" (3.2 cm) for PT9550) 11⁄4" (3.2 cm) 91⁄2" (24.1 cm) max. right side only 47" (119.4 cm) 12" (30.5 cm) 31-10856-1 04-13 GE 2 D CUTOUT FOR INSTALLATION OVER A WARMING DRAWER NOTE: Install the oven only with specific models listed on the label located on top of the oven. NOTE: Additional clearances between cutouts may be required. Check to be sure the oven supports above the Warming Drawer location do not obstruct the required interior depth and height. When installing a Warming Drawer below a single or double oven, a separate 120V, 60 HZ, properly grounded receptacle must be installed. Refer to installation instructions packed with the Warming Drawer for specific installation requirements. Anti-Tip Block Against Rear Wall Per Warming Drawer Requirement 2" (5.1 cm) Min. Per Warming Drawer Requirement Continue to Section 3 for DWO with Pedestal. Otherwise, continue to Section 4.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
2
C
CUTOUT FOR DOUBLE OVENS
(2 THERMAL OVENS)
NOTE:
If the cabinet does not have a front frame and the sides are less than ¾” (1.9 cm) thick, shim
both sides equally to establish the cutout width.
Dim.
Description
27” Double Oven
30” Double Oven with
Pedestal
30” Double Oven
without Pedestal
A
Cabinet Width
27” (68.6 cm)
30” (76.2 cm)
30” (76.2 cm)
B
Cutout Width
25” (63.5 cm) min.
25
1
⁄
4
” (64.1 cm) max.
28
1
⁄
2
” (72.4 cm) min.
28
5
⁄
8
” (72.7 cm) max.
28
1
⁄
2
” (72.4 cm) min.
28
5
⁄
8
” (72.7 cm) max.
C
Cutout Height
49
11
⁄
16
” (126.2 cm) min.
50
1
⁄
8
” (127.3 cm) max.
51
13
⁄
16
” (131.6 cm) min.
51
15
⁄
16
” (131.9 cm) max.
50 ¼” (127.64cm)
D
Overlap of Oven
Over Side Edges
of Cutout
1” (2.5 cm)
11
⁄
16
” (1.75 cm)
11
⁄
16
” (1.75 cm)
E
Clearance to
Adjacent Corners,
Drawers, Walls, etc.,
When Door Is Open
23” (50.8 cm) min.
23” (53.3 cm) min.
23” (53.3 cm) min.
F
Overlap of Oven
Top of Cutout
1” (2.5 cm) min.
1” (2.5 cm) min.
(1
1
⁄
4
” (3.2 cm) for PT9550)
1” (2.5 cm) min.
(1
1
⁄
4
” (3.2 cm) for PT9550)
G
Overlap of Oven
Bottom of Cutout
1” (2.5 cm) min.
1
1
⁄
4
” (3.2 cm)
1
1
⁄
4
” (3.2 cm)
H
Junction Box
Location
8
3
⁄
4
” (22.2 cm) max.
right side only
9
1
⁄
2
” (24.1 cm) max.
right side only
9
1
⁄
2
” (24.1 cm) max.
right side only
J
Height to Bottom
of Junction Box
44” (111.8 cm)
47” (119.4 cm)
47” (119.4 cm)
K
Recommended
Cutout Location
from Floor
13
1
⁄
4
” (33.7 cm)
12” (30.5 cm)
12” (30.5 cm)
31-10856-1
04-13 GE
2
D
CUTOUT FOR INSTALLATION OVER A WARMING DRAWER
NOTE:
Install the oven only with specific models listed on the label located on top of the oven.
NOTE:
Additional clearances between cutouts may be required. Check to be sure the oven supports
above the Warming Drawer location do not obstruct the required interior depth and height.
When installing a Warming Drawer below a single or double oven, a separate 120V, 60 HZ, properly
grounded receptacle must be installed. Refer to installation instructions packed with
the Warming Drawer for specific installation requirements.
Anti-Tip Block Against
Rear Wall Per Warming
Drawer Requirement
2" (5.1 cm)
Min.
Per Warming
Drawer
Requirement
Continue to Section 3 for DWO with Pedestal. Otherwise, continue to Section 4.
Continue to Section 3.
H
B
C
K
F
G
D
A
J
E
Junction
Box
Location
(junction
box may
be located
in adjacent
cabinet)
Cutout Depth
23-1/2”
(59.7 cm) Min.