GE SCA1000H Owners Manual - Page 43

Troubleshooting www.geadvantium.com Questions? Use this problem solver or visit the GE website at www.GEAppliances.com Problem Possible Causes LIGHTS Light during a speedcook cycle dims and cycles on and off, even at full power levels This is normal. Power level has been automatically reduced because the oven is hot. Light visible around the door and outer case while speedcooking This is normal. FAN Fan continues to run The oven is cooling. after cooking stops Oven vent emits warm This is normal. air while oven is on Fan comes on This is normal. automatically when oven not in use Fan comes on This is normal. automatically when using the microwave COOKING The oven makes unusual sounds while cooking Smoke comes out of the oven when I open the door Clicks and fans blowing are normal. The relay board is turning the components on and off. Food is high in fat content. Aerosol spray used on the pans. Food is not fully cooked or browned at the end of a cooking program Programmed times may not match the size or amount of food you are cooking. What To Do/Explanation • This is normal. The oven senses the heat level and adjusts automatically. • When the oven is on, light may be visible around the door and outer case. • The fan will automatically shut off when the internal parts of the oven have cooled. • If the cooktop gets too hot, the vent fan comes on. • If the microwave is used after speedcook and the oven senses that it is too hot, the vent fan comes on to cool the oven. • These sounds are normal. • Smoke is normal when cooking highfat foods. Use vegetable oil or olive oil on the meat itself instead of coating the entire pan. • Increase or decrease time for doneness or adjust the upper or lower lamps for browning. 43