Gigabyte B650 AERO G User Manual - Page 16
Back Panel Connectors, SMA Antenna Connectors 2T2R, USB 2.0/1.1 Port, DisplayPort In port
View all Gigabyte B650 AERO G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
2-6 Back Panel Connectors SMA Antenna Connectors (2T2R) Use this connector to connect an antenna. Tighten the antennas to the antenna connectors and then aim the antennas correctly for better signal reception. USB 2.0/1.1 Port The USB port supports the USB 2.0/1.1 specification. Use this port for USB devices. DisplayPort In port The DisplayPort In port offers video outputs to the motherboard. Refer to the pictures below and the USB Type-C® (USB 3.2 Gen 2) port for more information. Step 1: Connect the included DisplayPort cable from the graphics card to the DisplayPort In port on the back panel. Step 2: Then connect the USB Type-C® or DisplayPort devices to USB Type-C® port to complete. HDMI Port The HDMI port is HDCP 2.3 compliant and supports Dolby TrueHD and DTS HD Master Audio formats. It also supports up to 192KHz/24bit 7.1-channel LPCM audio output. You can use this port to connect your HDMI-supported monitor. The maximum supported resolution is 4096x2160@60 Hz, but the actual resolutions supported are dependent on the monitor being used. After installing the HDMI device, make sure to set the default sound playback device to HDMI. (The item name may differ depending on your operating system.) USB 3.2 Gen 2 Type-A Port (Red) The USB 3.2 Gen 2 port supports the USB 3.2 Gen 2 specification and is compatible to the USB 3.2 Gen 1 and USB 2.0 specification. Use this port for USB devices. •• When removing the cable connected to a back panel connector, first remove the cable from your device and then remove it from the motherboard. •• When removing the cable, pull it straight out from the connector. Do not rock it side to side to prevent an electrical short inside the cable connector. - 16 -