Gigabyte GA-790XTA-UD4 Manual - Page 76

B. Configuring SATA controller mode in BIOS Setup Make sure to configure the SATA controller mode correctly in system BIOS Setup. Step 1: Turn on your computer and press to enter BIOS Setup during the POST (Power-On Self-Test). Ensure OnChip SATA Controller is enabled under Integrated Peripherals. To enable RAID for the SATA2_0/1/2/3 connectors, set OnChip SATA Type to RAID. To enable RAID for the SATA2_4/5 connectors, set OnChip SATA Type to RAID and set OnChip SATA Port4/5 Type to As SATA Type (Figure 1). CMOS Setup Utility-Copyright (C) 1984-2009 Award Software Integrated Peripherals OnChip IDE Channel OnChip SATA Controller OnChip SATA Type OnChip SATA Port4/5 Type Onboard USB 3.0 Controller Onboard ESATA Controller Onboard ESATA Mode Onboard SATA3 controller Onboard SATA3 Mode GSATA RAID Configuration Onboard LAN Function Onboard LAN Boot ROM } SMART LAN Onboard Audio Function Onboard 1394 Function Legacy USB storage detect Onboard Serial Port 1 OnChip USB Controller USB EHCI Controller [Enabled] [Enabled] [RAID] [As SATA Type] [Enabled] [Enabled] [IDE] [Enabled] [IDE] [Press Enter] [Enabled] [Disabled] [Press Enter] [Enabled] [Enabled] [Enabled] [3F8/IRQ4] [Enabled] [Enabled] Item Help Menu Level  Move Enter: Select F5: Previous Values +/-/PU/PD: Value F10: Save F6: Fail-Safe Defaults ESC: Exit F1: General Help F7: Optimized Defaults Figure 1 Step 2: Save changes and exit BIOS Setup. The BIOS Setup menus described in this section may differ from the exact settings for your motherboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you have and the BIOS version. Appendix - 76 -