Gigabyte GA-EP45T-UD3P Manual - Page 105
B. Installing Windows Vista
View all Gigabyte GA-EP45T-UD3P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
B. Installing Windows Vista (The procedure below assumes that only one RAID array exists in your system.) Intel ICH10R SATA controllers: Step 1: Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps. When a screen similar to that below appears, select Load Driver. (Figure 8). Figure 8 Step 2: Specify the location where the driver is saved, such as your floppy disk or USB flash drive (Figure 9). Figure 9 - 105 - Appendix
Appendix
- 105 -
B. Installing Windows Vista
(The procedure below assumes that only one RAID array exists in your system.)
Intel ICH10R SATA controllers:
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation
steps. When a screen similar to that below appears, select
Load Driver
. (Figure 8).
Step 2:
Specify the location where the driver is saved, such as your floppy disk or USB flash drive (Figure 9).
Figure 9
Figure 8