Gigabyte GA-EP45T-UD3P Manual - Page 107
GIGABYTE SATA2 controllers, Load Driver
View all Gigabyte GA-EP45T-UD3P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
GIGABYTE SATA2 controllers: Step 1: Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps. When a screen similar to that below appears (RAID/AHCI hard drive(s) will not be detected at this stage), select Load Driver (Figure 12). Figure 12 Step 2: Specify the location where the driver is saved, such as your floppy disk (Figure 13). Figure 13 - 107 - Appendix
Appendix
- 107 -
GIGABYTE SATA2 controllers:
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation
steps. When a screen similar to that below appears (RAID/AHCI hard drive(s) will not be detected at this
stage), select
Load Driver
(Figure 12).
Figure 12
Step 2:
Specify the location where the driver is saved, such as your floppy disk (Figure 13).
Figure 13