Gigabyte GA-F2A85XM-HD3 User Manual - Page 17

DEBUG PORT 3/4) CPU_FAN/SYS_FAN (Fan Headers) All fan headers on this motherboard are 4-pin. Most fan headers possess a foolproof insertion design. When connecting a fan cable, be sure to connect it in the correct orientation (the black connector wire is the ground wire). The motherboard supports APU fan speed control, which requires the use of a APU fan with fan speed control design. For optimum heat dissipation, it is recommended that a system fan be installed inside the chassis. 1 Pin No. Definition 1 GND 2 +12V CPU_FAN 3 Sense 4 SpDeeEdBUCGontrol 1 PORT SYS_FAN DEBUG PORT •• Be sure to connect fan cables to the fan headers to prevent your APU and system from overheating. Overheating may result in damage to the APU or the system may hang. •• These fan headers are not configuration jumper blocks. Do not place a jumper cap on the headers. 5) SATA3 0/1/2/3/4/5/6/7 (SATA 6Gb/s Connectors) The SATA connectors conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA 1.5Gb/s standard. Each SATA connector supports a single SATA device. The AMD A85X Chipset supports RAID 0, RAID 1, RAID 5, RAID 10, and JBOD. Refer to Chapter 4, "ConDfiEgBuUrGing SATA Hard Drive(s)," for instructions on configuring a RAID array. PORT 1 DEBUG SATA3 7 PORT 6 7 Pin No. 1 2 Definition GND TXP 1 3 TXN 4 GND G.QBOFM G.QBOFM5 RXN SATA3 2 3 4 5 7 6 RXP 7 GND 7 1 7 1 SATA3 1 1 7 SATA3 0 1 7 •• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard drives are to be used, the total number of hard drives must be an even number. •• A RAID 5 configuration requires at least three hard drives. (The total number of hard drives does not have to be an even number.) •• A RAID 10 configuration requires four hard drives. - 17 -