Gigabyte GA-F2A85XM-HD3 User Manual - Page 18
F_PANEL Front Panel Header, Hard Drive Activity LED
View all Gigabyte GA-F2A85XM-HD3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
6) F_PANEL (Front Panel Header) Connect the power switch, reset switch, and system status indicator on the chassis to this header according to the pin assignments below. Note the positive and negative pins before connecting the cables. Message/ Power Sleep LED Switch PWPW+ MSGMSG+ 2 10 1 9 NC RES+ RESHD- HD+ Hard Drive Reset Activity LED Switch •• MSG (Message/Sleep LED): System Status LED S0 On S3/S4/S5 Off Connects to the power status indicator on the chassis front panel. The LED is on when the system is operating. The LED is off when the system is in S3/ S4 sleep state or powered off (S5). •• PW (Power Switch): Connects to the power switch on the chassis front panel. You may configure the way to turn off your system using the power switch (refer to Chapter 2, "BIOS Setup," "Power Management," for more information). •• HD (Hard Drive Activity LED): Connects to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data. •• RES (Reset Switch): Connects to the reset switch on the chassis front panel. Press the reset switch to restart the computer if the computer freezes and fails to perform a normal restart. •• NC : No connection. The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assignments are matched correctly. - 18 -